The Snap-N-Trac system is a new concept in boat storage organizer systems, its modular design provides the angler the ability to arrange essential tools and tackle in a way best suited to their fishing and boating needs. Snap-N-Trac is far removed from the inductry standard Lick & Stick static one size fits all products that have been around for several decades. Over the years the only changes made to these outdated suction cup systems was the addition by manufacturers of installation screws. Complaints by boaters that the suction cups did not hold were finally addressed but thats all. When you buy a static organizer product you have to adapt to the product, when you buy Snap-N-Trac it adapts to you.

The Snap-N-Trac system incorporates the following essential qualities.

1- Its high quality components are made from light weight but very strong polypropylene plastic that will withstand the most severe weather conditions.

2- Its unique design and precise engineering provide both a custom look and superior functionality.

3- Its modular design and extra pieces allow boaters to modify the system design and or function as the boaters needs change.

4-Its secure installation insures that your Snap-N-Trac system will stay put even under the most severe sea conditons, your days of flying hooks and knives during rough seas are over.

EZ Installation.

First you need to decide if you want to install one full Snap-N-Trac system or break up your kit components to make several smaller systems starting in increments of 6". How many you can design will depend on how many 6" Trac Base sections your kit includes.

Once you have decided on what type of Snap-N-Trac system you want to install you then need to decide where on your boat you want to install it/them. For proper installation all you need is a flat area long enough to accomodate the Trac sections needed for the system you want to install.

You can either secure the trac base sections directly to your boat or you can secure the Snap-N-Trac system to a sub plate which you would secure directly to your boat. This sub plate can be made of Teak, Star Board, marine plywood or some other workable water resistant material. 

Once you have installed the interlocking Trac Base sections needed to build your system all you then need to do is attach the modular peices your prefer to use. Since these pieces can be removed you can modify your Snap-N-Trac system as needed using the extra unused pieces you have remaning in your kit.

Each designer kit comes with an assortment of pieces that allow the construction of a variety of unique design options.

Our 18" Tournament designer kit includes 15 various modular pieces that include 3-6" Trac Base sections, 1-4"Wx3,5"D - Drink holder, 2-3" Plier holders, 2-6" Hook & Lure holders, 2-1" Knife holders, 1-1"Spacer (to adapt as needed), 1-1" Hook Extractor holder (or other use), 1-1'Left End Cap and 1-1" Right End Cap.

With our 18" Tournament designer kit you have at least nine different design options to choose from, including 5- 18" systems, 2- different combination 12" & 6" systems or 2 different - triple 6" individual systems.

Our 12" Supreme designer kit includes 11 various modular pieces that include 2-6" Trac Base sections,1-4"Wx3.5"D-Drink holder, 1-3" Plier holder, 1-6" Hook & Lure holder, 2-1" Knife holder,1-1" Hook Extractor holder (or other use), 1-1" Left End Cap adn 1-1" Right End Cap.

With our 12" Supreme designer kit you have at least eight different design options to choose from, including 3-12" different systems or 5 different - combination 6" systems.

Along with the modular pieces each kit contains stainless installation hardware, instructions and pictures of the various design options you can build.